How you fix the steel door hinge depends on the amount of damage to the screw threads.
Metal storem door hinge loose.
However if the hinge has only three holes add a 3 in.
Open the door grasp it by the lock edge and move it up and down.
When the door is swung open the loose screws pull out of the threaded mounting holes.
Screws straight through the two holes toward the center of the door.
If the hinge and jamb are painted cut the paint around the leaf with a utility knife swing the leaf away from the jamb.
Door and butt hinges attach doors to structures or surfaces and allow them to open and close.
Before you grab your tools partly open the door from the outside and push the door up and down.
If the hinge screws have been loose for only a short time you may need to tighten them with a screwdriver.
When the metal frame on the hinge side of the door comes loose or the molding itself loosens the door sags and scrapes against the other side of the frame usually near the top.
Unscrew the broken hinge parts from the wall and from your storm door.
Step 3 measure the area where you will be installing your new hinge so that you can make sure to buy the right size.
The wrong way is a temporary fix not cool.
The door might sag scrape or bump the doorjamb when the screws or molding become loose.
Watch the hinge side of the door frame.
They are available in screw in and weld on styles and are used in a variety of applications including garage doors cabinets and glass doors.
If the door has a large hinge with four screw holes just drive 3 in.
Fixing screen door out of square first inspect the condition of the screen door and the extent of the larson storm door sagging or whichever brand of door you have.
Open the door wide and insert a wedge under the bottom outside corner to level it.
If you encounter movement at the hinge screws they need to be retightened.
Fix it the right way not the wrong way.
Since you will not be needing the hinge or the screws again go ahead and put the screws and broken hinge to the side and out of the way.
Screw through the middle hole and redrill the top screw hole at a slight angle so the screw hits solid wood.
Remove the screws that hold the loose hinge leaf to the door jamb.